TEL:(86) 511 8443 6131
Home | Products | Products Finder | About Us | Resource Center | Contact Us
  RF Coaxial Connectors
  1.85mm Connector
  2.4mm Connector
  2.92mm Connector
  7/16 connector
  BNC/RPBNC Connector
  MCX Connector
  MMCX Connector
  N-Type Connector
  SMA & RPSMA Connector
  SMP Connector
  SMB Connector
  SSMA Connector
  TNC & RPTNC Connector
  TNCA Connector
  RF Coaxial Adapters
  RF Cable Assembly
  RF Coaxial Termination
  RF Surge Arrestor
  RF Coaxial Cable
N Plug to Jack (1/4 λ) Surge Arrestor [P/N: SA(1/4)-N-PJ5003]

CMPTER P/N: SA(1/4)-N-PJ5003
Gas Tube:
Unprotected Side(Port1): N plug(male)
Protected Side(Port2): N jack(female)
RoHS Certificate: Complaint
Interface Standards: IEC61643-21
Lighting and Surge Standard: IEC61643-21
Series Data Sheet: Customer Drawing [PDF]

Arrestor adopts “1/4λ” coaxial protection technology
Part NO.: SA(1/4)-N-PJ5003
Lighting and surge standard: IEC61643-21
Technical Data
Impedance 50 Ohm
Frequency range 800 — 960 MHz
VSWR ≤ 1.1
Max. peak power 500W
Contact resistance ≤ 1 mΩ (center contact)
≤ 0.25 mΩ (outer contact)
Insertion loss ≤ 0.1dB
Discharging current ≥ 15 kA@8/20μS
Residual Voltage < 15 V@8/20μS
Mating 5/8-24UNEF threaded coupling nut
Interface N Plug to N Jack
Temperature Range -40 °C to +70 °C
Relative Humidity < 95%
Waterproof IP 67
a. The protector should be placed at the input to the installation and preferably near sensitive equipment.
b. All protectors to be installed must be interconnected and connected with equipotential ground network.
c. In order to minimize the residual voltages, the screws (M4x5)should be tightened up and the
    connection of the protector to the ground network should be as short as possible (less than 50cm) and
    has the largest possible cross-sectional area (at least 4mm2 ).
















  Recommended Products:
Home | About us | Contact us | Disclaimer | Privacy Policy | Site Map | Cmpter Electronics Co., Ltd.
Tel:(86)511 8443 6131 Fax:(86)511 8717 7136
Copyright © Cmpter Electronics 2013